REED R5030 AC/DC True RMS Clamp Meter
With a non-contact AC voltage detector in it’s clamp tip the Reed R5030 clamp meter becomes a quick and versatile diagnostic tool for finding out why an electrical system or piece of electrical equipment is not operating correctly. Applications for the REED R5030
- Industrial maintenance technicians
- Control technicians
- Electricians
- Facilities
- Building maintenance and HVAC technicians
- Repairing existing systems on an as-needed basis
- Troubleshoot installation problems
- Perform final circuit tests
- Perform scheduled and preventive maintenance on electro-mechanical and electrical systems
- Industrial equipment and controls
- Commercial/industrial HVAC systems
| AC/DC Current Clampmeter | |
| Range | 50.00, 500.0A |
| Accuracy | AC: ±(2.8% rdg. +30 dgt.) DC: ±(2.5% rdg. +30 dgt.) |
| AC/DC Voltage | |
| Range | AC: 500.00mV, 5.0000, 50.000, 500.00, 750.0V DC: 500.00mV, 5.0000, 50.000, 500.00, 1000.0V |
| Accuracy | AC: ±(1.0% rdg. +30 dgt.) DC: ±(0.1% rdg. +4 dgt.) |
| Resistance | |
| Range | 500.00Ω, 5.000, 50.000, 500.00kΩ, 5.0000, 50.000MΩ |
| Accuracy | ±(1.0% rdg. +4 dgt.) |
| Frequency | |
| Range | 10.000kHz |
| Accuracy | ±(0.5% rdg. +10 dgt.) |
| Capacitance | |
| Range | 500.00, 5000.0nF, 50.00, 500.0µF, 5.000mF |
| Accuracy | ±(3.5% rdg. +10 dgt.) |
| Temperature | |
| Range | -100.0 to 1000.0°C/-148.0 to 1832.0°F |
| Accuracy | ±(1.0% rdg. +2.5°C/4.5°F) |
| General Specifications | |
| Display | 50,000 count LCD |
| Power Supply | Two AAA 1.5V batteries |
| Jaw Opening | 30mm |
| Dimensions | 198 x 66 x 36mm |
| Weight | 230g |
What’s included with the REED R5030
- R5030 500A AC/DC True RMS Clamp Meter
- Set of Test Leads
- Temperature Probe
- Batteries
- Soft Carrying Case
Battery Replacement
- Remove the Phillips screw on the back of the meter
- Open the battery compartment
- Replace the dead batteries and close the battery compartment Safety
- Do not exceed the maximum allowable input range of any function
- Do not apply voltage to the meter when resistance function is selected
- Set the function switch OFF when the meter is not in use Warning
- Set the function switch to the appropriate position before measuring
- When measuring volts do not switch to current/resistance modes
- When changing ranges using the selector switch always disconnect the test leads from the circuit under test
- Do not exceed the maximum rated input limits
